RCCN WeChat QrCode
Mobile WebSiteFor the test of the elongation of the automotive wiring harness, it is necessary to carry out the inspection according to the elongation and the relevant national standards. If the customer has special requirements, it shall be strictly controlled according to its requirements.
The specific step is to open the elongation tester switch, and then carefully observe the left of the sensor clip is not in the original position, the instrument above the readings are not zero, if the left of the sensor clip is not in the original position , The instrument shown above the reading did not return to the words, then immediately press the recovery key and set the zero key. And then gently open the sensor clip, the need to test one of the copper wire in the induction clip inside, and then press the sensor clip, then pull the copper wire and the other end of the other inside the folder, pressure Under the induction clip, the copper clamp, press the test button.
Finally, when the sensor clamp cuts the copper wire and stops moving, observe the readings above the instrument, and the above reading is the elongation of the copper wire that needs to be detected.
