RCCN WeChat QrCode
Mobile WebSiteElectronic Wire Harness Processing In the process of assembly, automotive wire harness processing is subject to certain principles. To this end, several points need to be noted when assembling some wire harnesses:
1. When assembling, do not pull the harness too tightly. This can prevent the vehicle from being jolted and causing displacement of the fixed point of the harness, resulting in an increase in the distance between the two fixed points. The wiring harness causes the virtual connection or the pull-off of the internal contact of the wiring harness, the change of the wire parameters, and in severe cases it also breaks the wire.
2. After the wiring harness is assembled, there must be enough clearance around it to allow it to pass through. In this way, it can be ensured that it will not be pressed by other components and will not be picked up by the components. This will prevent the insulation layer of the wiring harness from being worn or cracked or It is pinched off, causing a fault such as grounding.
3, not close to the location of the layout of the same color and type of connector, so as to prevent mis-insertion in the assembly, damage to electrical appliances and wiring harness.
4. The connector must be placed in an easy-to-find place and be placed in a place where tools and hands are easy to operate. This is mainly for convenience of inspection and maintenance. The length of the wire must be taken into consideration according to the actual assembly. If the electrical device is installed in a place where it is easy to operate, then it is possible to eliminate the need to directly connect the connector to the component; if the position of the electrical device is more secretive, later inspection and maintenance will be more difficult. The length of the wire of the electrical device can be appropriately increased according to specific needs, so that the connector is arranged at a place convenient for inspection and maintenance.
