RCCN WeChat QrCode
Mobile WebSiteWire harness processing factory: It is necessary to do all the aspects of wire harness processing. In the process of wire harness processing and production, it is necessary to do the visual inspection and wire diameter inspection work to ensure the quality of the circuit and strictly control all aspects of production and processing to ensure the processing of wire harness. In the process of production in line with national standards, through its line inspection and quality control, to achieve efficient production and processing purposes.
Hold a piece of white paper in one hand and place it at 1-2 cm from the copper wire. The bobbin with the copper wire must be placed on the packaging table. The other hand rolls the bobbin of the copper wire for one week and visually checks whether the appearance meets the following specifications: smooth appearance, no black line, no chaotic line, no pitting, no oxidation, no smearing, no scratches, no plating Tin is poorly tinned, tin is not slashed, no hand joints, no fingerprints. The cable is good, uniform, no stacking, low edge on the low side or low on both sides. The tension is moderate but too loose or too tight. After rolling, the surface of the copper wire has no sticky ash.
In the process of wire harness processing, the quality control standard of this link should be done. A series of inspection and measurement standards should be used to analyze the current situation to ensure the wire harness processing to do all the work, control the production quality from the source, and improve the wire harness. The failure rate of processing is to achieve true high efficiency and high quality production.
