Wiring duct,Cable Gland,Cable Tie,Terminals,RCCN

Many users are very confused when using cable connectors. If there is a problem with the quality of the cable connector or there is a problem in other places, it may cause a big accident. The following standards require all people who have contact with the cable connector to know ---

    1. Always check its arrangement and preparation before using the cable connector.

    2. Before dismantling, estimate the length of each cable according to the plan and the facts. Properly handle each cable to reduce the cable joint. It is better to leave a spare length around the extreme point and the joint.

    3. Cable connectors must meet several conditions:

    a. The cable removed together makes it best to separate the joints;

    b. When the cable connector is removed, the pallet needs to have a stable position;

    c. To buy a cable connector shell, you need a box to avoid mechanical damage. Of course, if you are in the box inside the frozen soil, you should pay attention to the asphalt.

    4. For the split cable joints, the cables must be turned on both sides of the cable and on both sides of the cable joint.

    5. Set the cable at a distance of 50 to 100 m in a straight line and where the cable joints are, as well as turning points and entering the building, etc., you need to set a clear position or standard pile.

    6. The cable end system and the cable connector and the oil supply cable supply system need to be firm and stable, and absolutely no oil leakage can occur.

    7. At the ends of the cable connector, the length of the cable near it should be 2 to 3 meters in length to increase the coating or the fireproof belt. Sometimes it is necessary to use a very high-strength explosion-proof refractory box to close it.