Wiring duct,Cable Gland,Cable Tie,Terminals,RCCN

Harness is made of copper by the contact with the terminal (connector) and wire and cable crimp, outside the plastic pressure insulator or external metal shell, etc., to bundle the formation of connecting circuit wiring components. In short, is to connect the car electrical wiring, the car operating conditions and parameters are reflected through the wiring harness in the car above the computer. On the other hand, the electronic technology of automotive wiring harness has become an important indicator of vehicle performance. And wiring harness in the processing of quality inspection should pay attention to what matters? Here to analyze.

Cutting line:

Check the size of the wire is not in line with the relevant requirements, the model is not correct. The incision must be neat, can not scratch the wire, and the wire can not have dirty situation.

Grouping:

Check the pruning is not neat, the size of the right, in the trim group when the line can not be assigned to the core.

Stripping the skin:

Check the stripping mouth is not neat, stripping the size of the wrong, can not be stripped of marshalling wire and core.

Peel the skin:

Check the stripping mouth is not neat, stripping the size of the right, there is no core stripping, there is no stripping copper wire; in the semi-stripped when the insulator must not fall off.

Sets of shrink tube:

Carefully check the type of shrink tube and the size is not correct.

Prepare solder:

Check the temperature of the tin furnace on the right; in the preparation of solder before the core and copper wire should be finishing, check there is no bending, bifurcation and discount situation.